Owner manual

Instruction Manual
3
PreparingYourSite
1. Determinewherethelocalvideosource(i.e.computer,PVR/DVR)willbelocatedand
physicallysetupthevideosourcedevice.
2. Determinewheretheremotedisplay(s)willbelocatedandplace/mountthe
display(s)appropriately.
Please notethatbothextenderunits(transmitter/receiver)willrequireapower
connection,sopleaseensurethateachunitwillbesituatednearanavailableelectrical
outlet.
3. Ifyouareusingsurfacecabling,ensureyouhaveenoughCat5unshieldedtwisted
pair(UTP)EthernetcablingtoconnecttheTransmitterUnittotheReceiverUnit’s
location,andthateachendisterminatedwithaRJ45Ethernetconnector.The
cablingshouldnotgothroughanynetworkingequipment(i.e.router,switch).
OR
Ifyouareusingpremisecabling,ensurethattheCat5unshieldedtwistedpair(UTP)
EthernetCablingbetweentheTransmitterUnitandtheReceiverUnithasbeen
properlyterminatedinawalloutlet/panelineachlocationandthereisapatch
cablelongenoughtoconnecttheReceiverUnitandtheTransmitterUnittotheir
respectiveoutlets.Thecablingshouldnotgothroughanynetworkingequipment
(i.e.router,switch).