Instruction manual

2
Installation
WARNING! Hard drives require careful handling, especially when being
transported. If you are not careful with your hard disk, lost data may result.
Always handle your hard drive and storage device with caution.
Hardware Installation
1. Remove the rear panel, to expose the internal SATA connections:
2. Position the hard drive you wish to install such that the SATA connection
is facing towards the SATA interface connector provided by the
Enclosure’s front panel:
3. With the hard drive connected to the front panel, turn the drive over to
expose it’s base. Fasten the hard drive to the front panel rails on both
sides, using the screws provided (2):