Manualshelf

Instruction manual

ManualsBrandsStarTech.com Manualschassis componentsSAT2510U2REM
12345678910
Instruction Manual
3
Installing the hard drive in the drive enclosure
1. Remove the two screws from the rear panel of the Drive Enclosure. Remove the rear
panel of the Drive Enclosure.
2. Remove the circuit board from the drive enclosure.
3. Attach the 2.5” SATA hard drive to the circuit board, and fasten it to the board using
drive mounting screws.
4. Once the hard drive has been secured on the circuit board, replace the circuit board
(with hard drive attached) in the drive enclosure. Fasten the rear panel of the drive
enclosure to the enclosure, using the screws that were removed in step #1.