Installation guide

3
Software installation and configuration consists of the following:
A. Running the NETRS232 setup software
C. Activating and deactivating NETRS232 ports
D. Optional advanced port configuration
B. Configuring network settings
Software Installation
and Configuration
A. Running the NETRS232 setup software
B. Configuring network settings
The installation diskette has files to
install NETRS232 drivers on your PC and
to detect s on your
network.To run the installation software,
insert the installation diskette and run
"Setup.exe".The Setup Wizard will ask
you to supply basic installation
information.
The displays NETRS232 information in a Windows Explorer-like
interface. Any NETRS232 devices that are discovered on your network are displayed in
the "IP-Extenders Near Me" branch of the "My IP-Extender Network" tree.
NETRS232 devices installed on your network will need unique IP addresses.These can
be set by using either the a web browser, or a Telnet client.
The factory default network settings for the NETRS232 are:
IP address: 192.168.0.35
Subnet mask: 255.255.255.0
Gateway address: 0.0.0.0
Name: [empty]
Workgroup: [empty]
DHCP detection: disabled
,
NETRS232 device
IP-Extender Manager
IP-Extender Manager
IP-Extender Manager
The Setup Wizard will finish by opening
the . By default the
will display
NETRS232 devices that it has detected on
your network.
IP-Extender Manager