Instruction manual

18
Manual Scan enables you to manually switch back and forth between
power-on computers.
Left Ctrl + left Ctrl + F2
Press < > or < > to select the previous or the next computer in
sequence. Press any other key to abort the Manual Scan.
* Note: Scan Type determines whether an eye-marked computer is to
be displayed during Auto Scan.
To adjust Scan Rate which sets the duration before switching to the
next computer in Auto Scan:
Left Ctrl + left Ctrl + F3
The LCD Rack Console sends one to four beeps indicating scan
interval of 3, 8, 15 and 30 seconds respectively. To adjust keyboard
typematic rate (characters/sec), this setting over-rides that of BIOS and
any operating system:
Left Ctrl + left Ctrl + F4
The Console will generate 1 to 4 beeps corresponding to 10, 15, 20
and 30 characters/sec respectively.
Change Configuration while Running
A device (a computer or a KVM switch) at any ‘PC x’ port can be
changed at any time after initial power-up. If you change any one of
the PC 1 to PC 8 ports connection from a computer to a Slave or vice
versa, or replace the devices of a port, the OSD will update this change
the next time it is activated.
* Note: Any new device must be turned off before it is connected to
the Master.