Instruction manual

15
Auto Scan
In this mode, the Console automatically switches from one powered
computer to the next, sequentially in a fixed interval. During Auto Scan
mode, the OSD displays the name of the selected computer. When
Auto Scan detects any keyboard or mouse activity, it suspends the
scanning until activity stops; it then resumes with the next computer in
sequence. To abort Auto Scan mode, press the left <CTRL> twice, or,
press any front button. Scan Type and Scan Rate set the scan pattern.
Scan Type (<F4>:More\Scan Type) determines if scanned computers
must also be eye mark selected. Scan Rate (<F4>:More\Scan Rate)
sets the display interval when a computer is selected before selecting
the next one.
Manual Scan
Scan through power-on computers one by one by keyboard control.
Scan Type (<F4>:More\Scan Type) determines if scanned computers
must also be eye mark selected. Press the < > key to select the
previous computer and the down arrow key to select the next computer.
Press any other key to abort Manual Scan mode.
Audio Stick
An optional multimedia module can be linked to the back of each KVM
Module for selecting microphone and stereo speaker signals. There
are two options for Audio Stick: On and Off. When set to On, audio
selection follows computer selection. When set to Off, audio selection
stops following computer selection. It is useful if you want to listen to
a particular computer’s audio signal while operating other computers.
The non-volatile memory stores the Audio Stick setting.
Scan Type
Ready PC + : In Scan mode, scan through power-on and eye mark
selected computers. Ready PC: In Scan mode, scan through power-on
computers. The non-volatile memory stores the Scan Type setting.
Scan Rate
Sets the duration of a computer displayed in Auto Scan mode. The
options are 3 seconds, 8 seconds, 15 seconds and 30 seconds. The
non-volatile memory stores the Scan Rate setting.