Specifications
Instruction Manual
3
Driver Installation (Non-boot drives)
1. Power on the computer.
2. Locate and execute the Setup.exe le on the Driver CD (included).
This program will copy driver les onto the host system. If you
wish to perform the installation manually, please ensure that you
have specied the correct le when asked (titled: JMB36X_WinDrv_
WHQL_R1.17.31WHQL\R1.17.31.00\Driver\x32jraid_i.inf ). Once
the les have been copied, restart your computer as prompted.
3. After the system reboots, Windows will locate the new hardware
RAID Controller and install the necessary driver.
4. Replace the computer chassis, and power on the computer.
Verifying Successful Driver Installation
Once the computer has been powered on following the driver installation and the connection
of the desired drive, you may wish to verify that the necessary les have been installed properly.
To do so:
1. Right-click on My Computer and select Manage.
2. In the left pane of the Computer Management window, select Device Manager.
3. In the right pane of the Computer Management window, click on SCSI and RAID
Controllers. Here, you should nd listed JMicron JMB36X RAID Controller and JMicron
JMB36X RAID Processor, upon successful installation.
Windows Vista™ Fresh Installation
Follow the instructions in this section if you are performing a new (bootable) installation of
Windows Vista™ on a drive attached to PEXSATA22I:
1. Shut down all power connected to the computer, as well as all
devices connected to the computer peripherally (i.e. Printers,
Monitors, Scanners etc.). As an added step to ensure safe
installation, unplug the power supply from the computer.
2. Remove the computer cover, allowing access to the motherboard
and available slots. For more detailed instruction on how to perform
this step, please refer to the documentation that was included with
your computer at the time of purchase.
3. Locate an empty PCI Express slot, removing the metal bracket
covering the accompanying empty port/socket on the rear panel of
the computer chassis.
4. Position the card above the open PCI Express slot, ensuring that the
card is properly aligned with the slot. Insert the card rmly into the
slot, distributing force evenly across the length of the board.