SATA PCI Express Adapter PEXESATA2I
FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Instruction Manual Table of Contents Introduction ................................................................................... 1 Package contents.........................................................................1 System Requirements..................................................................1 Installation....................................................................................... 2 Driver Installation (Non-boot drives).............................................
Instruction Manual Introduction Thank you for purchasing a StarTech.com SATA II PCI Express Adapter. Supporting SATA II data transfer speeds of up to 3.0 Gbps, this dual port eSATA/SATA II PCI Express Card offers users a cost-effective solution for connecting additional SATA II drives and provides RAID capable operation.
Instruction Manual Installation WARNING! PCI Express cards, like all computer equipment, can be severely damaged by static electricity. Be sure that you are properly grounded before opening your computer case or touching your card. StarTech.com recommends that you wear an anti-static strap when installing any computer component.
Instruction Manual your computer at the time of purchase. 3. Locate an empty PCI Express slot, removing the metal bracket covering the accompanying empty port/socket on the rear panel of the computer chassis. 4. Position the card above the open PCI Express slot, ensuring that the card is properly aligned with the slot. Insert the card firmly into the slot, distributing force evenly across the length of the board.
Instruction Manual 3. In the right pane of the Computer Management window, click on SCSI and RAID Controllers. Here, you should find listed JMicron JMB36X RAID Controller and JMicron JMB36X RAID Processor, upon successful installation. Windows Vista™ Fresh Installation Follow the instructions in this section if you are performing a new (bootable) installation of Windows Vista™ on a drive attached to PEXESATA2I: 1.
Instruction Manual 8. Start the computer as you normally would to perform an operating system installation, ensuring that the Windows Vista™ installation CD/DVD is present in the drive, and the BIOS has been suitably adjusted to boot from the CD/DVD Drive. 9. When the Windows Install screen appears, fill in the necessary information and click Next. Follow the operating system instructions until a page appears asking “Where do you want to install Windows?”. From here, click on Load Driver. 10.
Instruction Manual the computer chassis. 4. Position the card above the open PCI Express slot, ensuring that the card is properly aligned with the slot. Insert the card firmly into the slot, distributing force evenly across the length of the board. Once inserted, secure the card into the adjoining socket (previously covered by metal bracket, on the rear panel of the computer chassis), using the correct size screw (if necessary, please consult documentation that accompanied purchase of computer). 5.
Instruction Manual Installation Without a Floppy Drive In the absence of an available floppy drive for driver installation, once PEXESATA2I has been installed within the computer, install the desired hard drive using an existing SATA controller, as provided by the motherboard. Then: 1. Power on the computer, and boot from the operating system Boot CD, and follow Microsoft’s Windows installation procedure to complete the operating system installation. 2.
Instruction Manual Specifications Chipset Connectors JMicron JMB363 1 x SATA II port (internal) 1 x eSATA port (external) Maximum Data Transfer Rate 3Gbps OS Support OS Support: Windows® 2000, XP, Vista™ Regulatory Certifications CE/FCC/ROHS Product Weight 44.2 g (1.42 oz ) Product Dimensions 102 x 120 x 20mm (L x W x H) (1.7 x 4.74 x .
Instruction Manual Technical Support StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads. Warranty Information This product is backed by a lifetime warranty. In addition, StarTech.
StarTech.com has been making “hard-to-find easy” since 1985, providing high quality solutions to a diverse IT and A/V customer base that spans many channels, including government, education and industrial facilities to name just a few. We offer an unmatched selection of computer parts, cables, A/V products, KVM and Server Management solutions, serving a worldwide market through our locations in the United States, Canada, the United Kingdom and Taiwan. Visit www.startech.
