Instruction manual

Instruction Manual
4
ii. Insert the cable that is connected to the receive (RX) connector on
the PCI Express Fiber Gigabit Ethernet Adapter into the transmit
(TX) connector on the network switch.
6. When the cable is properly connected to two end devices, turn on the
power to the PC.
7. Check the LNK (Link) LED. The LED will come on when the PCI Ex
press Fiber Gigabit Ethernet Adapter is receiving a good link signal
from the connected device, a switch.
Software Installation
1. Once PEX1000MMSC/PEX1000MMST has been installed in the
computer, turn on the power to the computer.
2. When the Found New
Hardware Wizard window
pops up, select Install from
a list or specific location
(Advanced)and click Next to
continue.
3. Select Search for the best
driver in these locations. and
then select Include this
location in the search. Click
Browse to specify the driver
location and click Next to
continue.