Instruction manual

Instruction Manual
4
ii. Insert the cable that is connected to the receive (RX) connector on
the PCI Express Fiber Gigabit Ethernet Adapter into the transmit
(TX) connector on the network switch.
When the cable is properly connected to two end devices, turn on the 6.
power to the PC.
Check the LNK (Link) LED. The LED will come on when the PCI Ex 7.
press Fiber Gigabit Ethernet Adapter is receiving a good link signal
from the connected device, a switch.
Software Installation
Once PEX1000MMSC has been installed in the computer, turn on the 1.
power to the computer.
When the 2. Found New
Hardware Wizard window pops
up, select Install from a list or
specific location (Advanced)
and click Next to continue.
Select 3. Search for the best
driver in these locations. and
then select Include this location
in the search. Click Browse to
specify the driver location and
click Next to continue.