Instruction manual

Instruction Manual
3
Connecting to a Network
Please note: You must connect the PCI Express Fiber Gigabit Ethernet
Adapter to the network before installing the network driver.
For connector type, cabling requirements, and maximum segment dis-
tance when connecting the PCI Express Gigabit Ethernet Adapter to your
network, please refer to the following tables.
Remove the protective covers from the PCI Express Fiber Gigabit 1.
Ethernet Adapter’s connector.
Prepare a network cable with corresponding connectors for the two end 2.
devices, one end to the PCI Express Fiber Gigabit Ethernet Adapter
and the other to a 1000Mbps fiber port on the network switch.
Connect the network cable to the connector on the PCI Express Fiber 3.
Gigabit Ethernet Adapter. This network cable consists of two individual
cables: one for ‘transmission (TX)’, and the other for ‘reception (RX)’.
Connect the other end of the network cable to a 1000BASE-SX/LX 4.
switch.
i. Insert the cable that is connected to the transmit (TX) connector on 5.
the PCI Express Fiber Gigabit Ethernet Adapter into the receive
(RX) connector on the network switch.
Connector Type
on Fiber Adapter
Wavelength of 850nm
Fiber Optic required
Maximum Distance
(* full-duplex)
SC Multi-mode, 62/125 µm 550 m
Connector Type
on Fiber Adapter
Wavelength of
1310nm Fiber Optic
required
Maximum Distance
(* full-duplex)
SC Single-mode, 10/125 µm 10 km
SC Single-mode, 10/125 µm 10 km
SC Single-mode, 10/125 µm 50 km