Owner manual

Instruction Manual
5
4. Follow the prompts to perform the following:
• Choose your card type
• Choose your Linux kernel version
• Rebuild your system
• Exit and reboot with new settings
The device name will be /dev/tty8[1--2] [a--h]
Card Denitions
Note: Card 1 is the card with the jumper ON.
Card Number Device Name
1 tty81?
2 tty82?
I/O Port Number Denitions
Port Number Device Name
A tty8?a
B tty8?b
C tty8?c
D tty8?d
For example, the device named /dev/tty82b is the device plugged into port B on card
Number 2.
Notes:
• The above installation procedure installs a module type driver. If you can not install
the driver successfully, you may need to use a kernel type driver. With kernel type
drivers, you may need to have the full source le for the Linux system and the source
le must be located in the /usr/src/linux directory. If your source le is in a dierent
location, you must move it or link it to the “usr/src/linux” directory.
• Each serial card needs an open IRQ for Plug and Play function.