Port Industrial RS232/422/485 Wireless/ Wired Serial Device Server NETRS232485W *actual product may vary from photos DE: Bedienungsanleitung - de.startech.com FR: Guide de l'utilisateur - fr.startech.com ES: Guía del usuario - es.startech.com IT: Guida per l'uso - it.startech.com NL: Gebruiksaanwijzing - nl.startech.com PT: Guia do usuário - pt.startech.com For the most up-to-date information, please visit: www.startech.
FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which this manual applies by the third-party company in question.
Table of Contents Product Diagram.....................................................................................1 Front View..................................................................................................................................................... 1 Side 1.............................................................................................................................................................. 1 Side 2.........................................................
Product Diagram Front View 1. LED for PWR1 2. LED for PWR2 3. LED for Ethernet Port 1 4. LED for Wireless LAN 5. LED for Serial Port Side 1 1. Terminal Block PWR1 (12~48V DC) 2. Power Jack PWR2 (12~48V DC) 3. Port RJ45 10/100 4. Reverse SMA Connector for the Antenna Side 2 1. Reset Button 2. DB-9 Serial Port 3.
Introduction Packaging Contents • 1x Serial over IP Device Server • 1x2dBi Antenna • 1x DIN-Rail Kit • 1x Wall-Mount Kit • 1x Software CD • 1x Installation Guide System Requirements • System Requirements • Windows® 8 (32/64bit), 7 (32/64), Vista(32/64), XP(32/64), 2000, Windows® Server 2008 R2, 2003(32/64).
DB-9 Connector Pinout DIP Switch Configuration DIP 1 DIP 2 Termination Configuration ON ON Termination for long distance 4-wire RS485/422 ON OFF Reserved OFF ON Termination for long distance 2-wire RS485 OFF OFF No termination for RS485/ 422 (short distance) Instruction Manual 3
Installation Hardware Installation The server can be installed on a DIN rail or it can be wall-mounted. Installation on a DIN-Rail: 1. Tilt the unit, making sure that the metal spring located at the back is positioned on top of the DIN rail. 2. Push the unit towards the rail until a “click” sound is heard. Installation on a Wall: 1. Remove the DIN-rail kit, if it is installed on the unit. 2. Install the wall-mount panel included using the 3 screws found in the package. 3.
Operation For full operation instructions, please visit www.startech.com/NETRS232485W 1. Start the DS-Tool, allow the install of the driver 2. Allow access to the DS-Tool on the Windows Firewall 3. Once the utility opens, click the “Broadcast” button to detect the device server. The default IP address of the device is “192.168.10.2”. 4. Once detected, click the checkbox beside the device you would like to configure, and then click the “Add” button to configure your desired IP settings (Static/DHCP).
To add a virtual COM port, please use the VCOM Wizard and follow the steps.
Specifications Interface Serial Ports 1 Supported Protocols ICMP, IP, TCP, UDP, DHCP, BOOTP, ARP/RARP, DNS, SNMP MIB II, HTTPS, SSH 1x DB-9 male, 1x RJ-45 Connectors 1x Reverse SMA Connector 1x DC Power 1x 3pin Terminal Block LED Indicator(s) 1x Ethernet Link, PWR1,PWR2, Wireless LAN, Serial Supported Serial Protocols RS232/422/485 Ethernet Link Speed 10/100 Mbps Wireless LAN Standards IEEE802.11b/IEEE802.11g Maximum Baud Rate 230.
Technical Support StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads. For the latest drivers/software, please visit www.startech.com/downloads Warranty Information This product is backed by a three year warranty. In addition, StarTech.
Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise. StarTech.com is your one-stop source for every connectivity part you need. From the latest technology to legacy products — and all the parts that bridge the old and new — we can help you find the parts that connect your solutions. We make it easy to locate the parts, and we quickly deliver them wherever they need to go. Just talk to one of our tech advisors or visit our website.
