Installation manual

7. Windows is now ready to install the best driver for

this device. Click “Next”.

8. Installation complete. Click “Finish”.

Checking the Installing

1. Open the System folder (My Computer, Control

Panel, System)

2. Click the “Device Manager” tab at the top of the

dialogue box.

3. Click the “+” in front of the Universal Serial

Bus Controller heading to see the USB

controller listing.

If the Installation is completed successfully, you should

see an entry for USB to Serial Cable.

Peripheral Installation

1. With the computer booted up and the ICUSB232

adapter already plugged into the computer’s USB

port, plug the peripheral into the ICUSB232; then turn

the peripherals On.

2. Follow the Installation Wizard’s on-screen instructions

to complete the installation.

Note: This procedure only occurs the first time you connect

up your peripheral. If your peripheral was previously

connected and configured for the RC-232 (COM) port, after

you perform the Adapter Installation and click Finish, the

driver will detect it and install it automatically.

Note: Under Windows 2000, if you connect a modem, you

must specify it as a Standard Modem.

icusb232manual 11/27/01 11:15 Page 5