Owner's manual

Instruction Manual
2
Installation
To ensure a quick and easy installation, please read through this section before
attempting to install this device.
WARNING: Hard drives require careful handling, especially when being transported. If
you are not careful with your hard disk, it may result in lost data. Always handle your
hard drive with caution.
WARNING: Hard drives, like all computer equipment can also be severely damaged
by static electricity. Be sure that you are properly grounded before opening your
computer case or touching any components. StarTech.com recommends that you wear
an antistatic strap when installing any computer equipment. If an anti-static strap is
unavailable, discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
WARNING: Do not bump, jar, or drop the device. Do not disconnect any cables or
power sources while the hard drive is active. This can result in data loss and possible
damage to the hard drive. Always make sure that your hard drive is fully spun down
before removing the device.
NOTE: Prior to installation, please ensure that the cover from both sides of the
computer case have been removed, as you would in order to install a conventional
hard drive. For further instruction on how to complete this step, please consult the
documentation that accompanied your computer at the time of purchase.
Prior to opening your computer case, please remove all power to the computer, as well
as all power connected to the computer peripherally.
1. Remove the covers of two (HSB320SATBK) or three (HSB430SATBK) successive drive
bays (i.e. adjacent to one another).
2. Insert the Multi-Drive Enclosure into the bays made accessible in Step #1, and gently
push it inward until the mounting holes located on the side panels of the enclosure
are aligned with the holes provided by the drive bays: