Owners manual

Instruction Manual
2
Introduction
Packaging Contents
• Multimedia memory card reader - Micro USB On-The-Go
System Requirements
• OTG-enabled device (Smartphone, tablet, etc.)
Hardware Installation
1. Insert your desired memory card into the specied memory card slot on the
FCREADU2OTGB.
2. (Only required for USB peripheral devices) If connecting a USB peripheral device,
connect the USB cable for your peripheral device to the USB peripheral port on the
FCREADU2OTGB. Then Using a Micro USB cable (not included), connect the USB
power source port on the FCREADU2OTGB to an available USB power source.
Note: The FCREADU2OTGB does not require a power source for standard card
reading operation.