Datasheet

Instruction Manual

Because Windows ME, 2000 and XP all natively support USB devices, and require no

driver installation. To begin using FCREADHC:

1. Ensure the host computer is powered. Insert the USB

type ‘A’ connector into an available USB port on the

host computer.

Windows ME, 2000, XP

2. Insert the remaining USB ‘Mini B’ connector into the

USB port on the side panel of the FCREADHC Card

Reader.

3. Windows will recognize that the Card Reader has

been connected, and will automatically install the

necessary drivers. You will notice several message

balloons near the taskbar (normally the bottom right

corner of the screen, near the clock) indicating that

new hardware has been detected.

4. Once Windows has completed the driver installation, a message balloon will appear

indicating that the new hardware has been installed and is ready for use. To begin

using the Card Reader, simply insert the card you wish to use into the appropriate

slot (based on size of card).

5. Browse to My Computer, where you will notice

several Removable Disks, indicating the installed

capabilities provided by the Card Reader. You can

now access the installed card, as though it were a

hard drive installed within the host computer.