Instruction manual

Instruction Manual

How to Setup RAID functions

Installation

Use a screw driver to loosen the two screws and slide in the 2.5” 1.

HDDs.

Note: If you want to build RAID functions, you must install two hard

drives at the same time.

Set the RAID mode on the DIP SW2.

a) To set the operating mode according to the above table:

i) Connect the USB or eSATA data and power cable to your system,

then, turn on the power from the RAID box rear panel. Wait until both

hard drives are powered on.

ii) Press the RAID Change Mode SW once to ﬁnish setting the RAID

mode. [*Note: If you want to use the default model setting (or re

place HDDs), you still must press the RAID Model Change SW

once].

Once the selected RAID mode is ready, you may partition/format the 3.

RAID-built HDDs. After the HDDs have been formatted, they are ready

to use.

Display RAID Status RAID Conﬁguration

4 2 1

0 BIG (span) OFF OFF OFF

1 JBOD (single) OFF OFF ON

2 FAST (strip) OFF ON OFF

3 SAFE (mirror) OFF ON ON

4 SAFE33 ON OFF OFF

5 SAFE50 ON OFF ON

6 RESERVED ON ON OFF

7 GUI ONLY ON ON ON