Quick Start Guide

Instruction manual
5
Assemble the workstation
Attach the pneumatic arm to the workstation
1. Line up the two holes on each of the brackets of the pneumatic arm (1) with four of
the holes on the workstation (5).
2. Use the M4*55 Allen wrench (13) to insert four M6*12 screws (15) into the two holes
on each side of the bracket on the pneumatic arm (1).
3. Turn the Allen wrench clockwise to tighten the screws.
4. Use the M4*55 Allen wrench (13) to insert two M6*35 screws (17) through the holes
on the sides of the pneumatic arm pedal and the plastic spacing washers (11) and
into the workstation (5).
5. Turn the Allen wrench clockwise to tighten the screws.
1
15
13
13
17
11
5