Owners manual

Instruction manual

D-ring hook hardware

D-ring hook

Mounting button

Attach a cable organizer

After you remove the mounting buttons or D-ring hooks, complete the following to

attach the cable organizer to your server rack:

1. Line up the mounting holes on the cable organizer with the mounting holes on any

of the following on your server rack:

• The vertical mounting plates.

• The horizontal mounting rails.

• The equipment-mounting holes.

Note: To view images of some of the dierent installation options mentioned above,

see the “Installation options” section.

2. Insert an M4 x 16 mm screw through the cable organizer and the server rack.

3. On the other side of the cable organizer and server rack, attach one of the 12 mm

washers and one of the M4 nuts to the screw.

4. Repeat steps 3 and 4 to attach a second screw.