Instruction manual

Instruction Manual
11
To change the leading hotkey sequence to Right <CTRL>:
Left <CTRL>, Left <CTRL>, hold <ALT>, press Right <CTRL>
All hotkey commands that previously required pressing the Left <CTRL> will be
switched to requiring the right <CTRL> instead.
To change the leading hotkey sequence back to Left <CTRL>:
Right <CTRL>, Right <CTRL>, hold <ALT>, press Left <CTRL>
Sun/Mac Keyboard Mapping
The KVM Switch emulates a Sun Keyboard when a computer is marked with a Sun, in
the OSD menu by Function Key <F5>. A Sun keyboard has more keys than a standard
PC keyboard. These extra keys are simulated by tapping the Right <CTRL> button,
which is normally located on the right lower part of the keyboard, followed by one of
the function keys on the general keyboard (i.e. combo key). For example, tap the Right
<CTRL> key, and then tap the function key F7 to activate Open for a Sun computer.
NOTE: For older Sun Operating Systems, the switch does not support the LowPower
option under Power O Select.
For keystroke emulation of Sun/Mac computers, please refer to the chart below and
conduct the following two examples:
Stop A function in Sun: Press right <CTRL> and release, then within two seconds press
F1 and A in sequence.
Help function in Sun: Press right <CTRL> and release, then within 2 seconds, press H.
STANDARD KEYBOARD SUN KEYBOARD MAC KEYBOARD
Press right <CTRL> and release <1>
Press right <CTRL> and release <2>
Press right <CTRL> and release <3>
Press right <CTRL> and release <4>
power
Press right <CTRL> and release <F1> <Stop>
Press right <CTRL> and release <F2> <Again>