User guide

Instruction Manual
3
Installation
WARNING! It is the installer’s responsibility to ensure that the combined weight of all
components does not exceed the maximum weight capacity 13.6 kg (30 lbs) of the
mounting arm.
Converting the Desk Clamp to a Grommet Clamp
The Dual Monitor Arm can be clamped to a desk / table, or mounted through a
grommet hole. The following instructions outline how to convert the default Desk
Clamp setup to a Grommet Clamp.
Skip to the next section (Desk / Grommet Mounting) if you are not using the Grommet
Clamp method.
1. Remove the 2 hex screws from the back of the desk clamp using the 4mm Allen
Wrench (9) to disconnect the bottom half of the clamp.
2. Remove the 4 hex screws from the base of the pole using the 4mm Allen Wrench (9)
to disconnect the top half of the clamp.