Instruction manual
Instruction Manual
3
Operating Your KVM Switch
To toggle between computers, you can use the hot-key commands, OSD (On-Screen
Display) menu or bu using pushbuttons.
Push Buttons
A solid red indicator reects the port selected. The indicator ashes red when in
Auto or Manual Scan mode. You can press any of the corresponding pushbuttons
to select the active computer. On the 16 port models, Port 1 and Port A share the
same pushbutton, as do Port 2 and Port B, etc. To select Ports 1 through 8, press the
pushbutton once. To select Ports A through H, press and hold the pushbutton for two
seconds. Alternatively, if Port 1 is currently selected and you want to select Port A, you
can press the pushbutton once to switch to Port A.
The K/M Reset function recongures your system without powering down your
computers or your KVM switch. To reset the switch, press and hold the front-panel 1
and 2 buttons simultaneously.
The Auto-Scan function automatically scrolls through your connected computers.
Press and hold the front panel 7 and 8 buttons simultaneously to enter Auto Scan
Mode.