Instruction manual

Instruction Manual

Web Conguration Using Static IP

Since some networks rely on static IP addresses (every device has a pre-congured

IP address that does not change), the DHCP access method described above is not

applicable in those situations.

To access the Web conguration for this product, you will need to congure the

workstation you are using to the same subnet (255.255.255.0) and also assign it a valid IP

address (i.e. 192.168.1.100). For details on how to change the IP address of your computer

(if necessary), consult your documentation or System Administrator for assistance.

NOTE: It is advisable to verify whether another device on your network is using the same

IP address as the IP KVM switch before connecting it to the network, to avoid a conict.

Should an IP address conict occur with another device on the network, power o the

conicting device or assign it another IP address before continuing the installation.

NOTE: Not all IP addresses are valid for a given subnet. If you are required to change

your subnet (and therefore IP address) to congure the unit, be sure the IP address you

choose is within the allowable range for the 255.255.255.0 subnet.

Once your computer is congured to the same subnet as the IP KVM switch, you can

use the IP address 192.168.1.123 to access the Web conguration system.