Instruction manual

Instruction Manual
4
PEX2S5521P:4. Connect the ribbon cable provided by the (separate)
parallel port to the provided slot on the PEX2S5521P board (please
see diagram on previous page), then secure the parallel port to the slot
adjacent to the one used to secure the main PEX2S5521P board.
OPTIONAL:5. If supplying power from the computer system power
supply, (see “Setting Power Mode”) connect the LP4 molex plug into
the card.
Once the card (and additional port, if necessary) are secured to 6.
the motherboard (and within the case), replace the computer cover
and power on the computer, then proceed to the next section, titled
Software Installation.
Software Installation
When the computer is booted up following the physical installation of the
PCI Express card, the operating system will detect the presence of the
card within the computer system and prompt for software installation:
The Found New Hardware Wizard will appear. When asked if you want 1.
Windows to search for software, select No, not this time, then click
Next to continue: