Instruction manual

Instruction Manual
3
Setting Power Mode
This card is specially designed to allow for power output from the ninth
pin of the DB9 connector(s) for devices that support power over serial.
This card allows users to set each port with 5V, 12V, or RI (no power).
Users can also choose to draw the necessary power from the system
power supply by connecting to the LP4 power connector.
Hardware Installation
Remove the cover of your system (see your computer’s user manual 1.
for details, if necessary) and gently turn your computer onto its side, so
that the PCI Express expansion slot openings on the motherboard are
facing upwards.
Locate an empty PCI Express slot and remove the metal plate that 2.
covers the corresponding rear bracket. You may need a Phillips screw
driver to perform this step. Retain any screws! You will need them to
secure the card later. Refer to documentation of your computer system
for further details.
PEX2S5521P Only: Please ensure that the metal plate that covers the
rear bracket adjacent to the above mentioned bracket is vacant, so that
it can be used for the parallel port installation).
Gently insert the card into the empty slot, making sure it is firmly 3.
seated, then secure the card in place using the screw you removed in
Step 3, if applicable.