Installation Manual

StarLink TrackerSF Installation Manual
ERM Advanced Telematics page: 8
5.1 Know the StarLink Family of Tracking Devices
1. Unwrap the device wire harness but do not connect it to the device yet.
Refer to the following wiring/color diagram of the StarLink connector
when performing connections in the subsequent steps of this procedure.
Brown wire | 10
Yellow wire | 9
Orange wire | 8
Purple wire | 7
White wire | 6
CAN Low
Port B / Out 2
General output
Port C / Out 3 / In 1
eNet2 (pull-up)
Port D / Out 4 / In 2
Dallas iButton (pull-up)
CAN High
Ground (-)
Port F / In 4 VSS
(pull-down)
PC Communication
LIN
Ignition input
(pull-down)
+12/24V
Black wire | 5
Blue wire | 4
Grey wire | 3
Green wire | 2
Red wire | 1
2. Connect the red wire (pin #1) via a 3A fuse to the vehicle battery
(+12V/+24V). Make sure this positive feed remains live even when the
Ignition switch is turned to OFF and when starting the engine. The fuse
must be removed from the fuse housing during installation.
3. Connect the black wire (pin #5) to the vehicle chassis or any grounded
part of the vehicle (GND).
Make sure the connection is free of paint or dirt to assure a good
conductive ground connection
4. Connect the green wire (pin #2) to the vehicle Ignition switch (IGN).
10 9 8 7 6
5 4 3 2 1
10 9 8 7 6
5 4 3 2 1