Installation Manual

StarLink TrackerSF Installation Manual
ERM Advanced Telematics page: 3
1. The StarLink 2G / 4G
This guide provides information about the StarLink 2G / 4G with internal eSafe and CAN,
and describes its recommended installation procedures.
2. Safety Instructions
Personal safety is of paramount importance. Please follow all safety
instructions when installing ERM products
• Always disconnect power when performing installation by removing the negative
connection of the vehicle battery. Never work when power is connected.
• Always connect the positive wire using a 3A fuse.
• Reconnect the battery only after the installation is fully completed, making sure all
wires are safely insulated.
• Use appropriate work tools.
• Maintain good ventilation and lighting in the work area.
• Never leave bared wires. Trim all wires not in use in such a way that no bare
conductors remain, and fix them securely in place.
• Perform installation in a dry environment.
ERM devices are not water-tight.
• Install ERM devices away from any heat sources.
• Do not install ERM devices in the engine compartment or on the vehicle’s exterior.
• Install ERM devices away from large metallic bodies and never install them in small
gaps between metallic objects.