Installation Manual

StarLink TrackerSF Installation Manual
ERM Advanced Telematics page: 15
5. Connect the power supply cable to a 12V power supply. you can use the
red and black connectors as described in the pictures below:
Use a screwdriver to connect the two
RED and BLACK connectors to the red
and black cables
Connect the connectors to the power
supply, remember to use 12V 1.5Amp
power supply
6. The final assembly is shown in the following figure.
7. Turn “on” the power supply and verify that the StarLink red LED begins
blinking after a few seconds.
8. You are now ready to configure your StarLink device. Connect the USB
cable to your PC and install the USB DRIVER as described in the
following paragraph:
USB
cable
eNet cable
StarLink
harness
Power and
Ignition
cable
USB
Adapter
module
12V,
1.5Amp
Power
supply
eNet
hub