Installation Manual

StarLink TrackerSF Installation Manual
ERM Advanced Telematics page: 14
If the eNet cable includes four wires (some only have three), cut the red
strand to prevent supplying 12V directly to the USB adapter.
You can use any port on the eNet hub to connect any of the cables.
3. Connect the StarLink device and the USB cable:
Connect the StarLink harness to the eNet
hub
Connect the USB cable to the USB
Adapter
4. Connect the power supply:
Connect one side of the power cable to
the eNet hub
Use the red and black wires for the power
supply (see section 5)