Installation Manual

StarLink TrackerSF Installation Manual
ERM Advanced Telematics page: 12
Do not install the StarLink device in close proximity to a metallic
surface.
4. If the vehicle's windows are metallic tempered the angle should be 0 º
(completely flat) toward the vehicle window.
5. When installing the unit in the vehicle pay close attention to the upper
space between the unit and the other components in the vehicle, the
unit should be in 20 cm away from any metal plate or metal
components that might block the GPS signal.
6. Make sure that the component / metal plate does not cover the entire
upper surface of the StarLink.
Please note for the following remarks while installing the StarLink:
• The StarLink device must not be installed next to heat sources or moving
parts.
• The installation position must be water proof.
• The StarLink device should be installed in the cabin or the trunk.
• The StarLink device should not be installed behind the fuse box.
• The StarLink device should be facing upwards to enable good GPS
reception.
• Never install the StarLink device with the antenna side next to metal
objects.
• The StarLink device must be installed by qualified service personnel only.
• All wires must be isolated after installation.
• The following figure shows an example of a good installation position: