Installation Manual

StarLink TrackerSF Installation Manual
ERM Advanced Telematics page: 10
7. Plug the harness connector into the device socket.
9. Approximately 10 seconds after powering up the
device, both the red and green LEDs should start
blinking.
The green LED indicates GPS reception.
The RED LED indicates communication with the GSM and a
connection with the server.
Before finally fixing the device in place, make sure it is properly
registered on your server and data has been transmitted as expected
10. To finalize the installation, fix the device in place – Opposite to driving
direction (note the THIS SIDE UP label) with a double-sided adhesive
sticker or with the cable ties threaded through the device side slits. (as
shown on the next page).
11. Reassemble any vehicle components you may have dismantled.
Green LED
Red LED