User Guide

Use
• Press the Multi-function button for two seconds
to power the Remote Microphone + on or off.
• The Remote Microphone + can be clipped to
clothing or worn on a lanyard.
• Remote Microphone + operating range is up to
30 feet (10 m). If the user walks out of range of the
Remote Microphone + audio stream, streaming
stops and will need to be manually restarted.
• The Remote Microphone + can stream for up to
10 hours on a full charge.
• The Remote Microphone + reaches a full charge
in three hours.
• The LED status indicator will blink red and an audible
indicator tone will play in the hearing aids every five
minutes when the Remote Microphone + battery is low.
• The Remote Microphone + will momentarily mute
if it is dropped and will resume streaming once
the device is stabilized.
• The Start/Stop streaming function as well as
the streamed audio volume level can be adjusted via
the Remote Microphone +, hearing aid user controls,
the 2.4 GHz Remote or the Thrive Hearing app.
• When the audio source is set to RemoteMicrophone+
or to Bluetooth for phone streaming, the
RemoteMicrophone+ should be within eight
inches (20 cm) of the speaker’s mouth. Wearing
the Remote Microphone + in a vertical position
provides the best performance
A
.
5
Volume +
Input
Mode
A
Pairing (Continued)
Pairing outside of Inspire X
1
Power off any mobile phone or other accessories
that were previously paired with the hearing aids.
2
Ensure the Remote Microphone + is powered on.
3
Power off, then power on the hearing aids to place in pairing mode.
4
Place the hearing aids within six inches of the Remote Microphone +.
5
Press the Input Mode and Volume Up buttons simultaneously for seven seconds
until the LED status indicator alternately blinks blue and red.
6
A green LED will blink for each hearing aid to confirm a successful pairing.
Pairing Remote Microphone + to Bluetooth Devices
1
Power off any mobile phone or other accessories that were previously
paired with the hearing aids.
2
Ensure the Remote Microphone + is powered on.
3
Press the Input Mode and Volume Down buttons simultaneously
for seven seconds until the LED status indicator rapidly blinks blue.
4
Put the Bluetooth device into pairing mode.
5
When the Remote Microphone + appears, select it on the Bluetooth device.
6
The Remote Microphone + LED will turn green for two seconds with successful pairing.
3
Volume −
Input
Mode