p r o g r a m m e r Installation Instructions
TABLE OF CONTENTS Description.......................................................................................2 Installation........................................................................................2 Operation.........................................................................................3 Safety Precautions...........................................................................4 Regulatory & Service Information..................................................
This document contains instructions for connecting SurfLink Programmer into your laptop or desktop PC via a USB connection. SurfLink Programmer requires that Inspire® 2011 fitting software or 3. Insert the rectangular end of the USB cable into an open USB port on your PC. higher is installed. 4. Follow the on-screen prompts in the “Add New Hardware. Wizard” screens. SurfLink Programmer is designed to be “plug and play” and does not require a CD or a restart of . the PC.
Safety Precautions Please read the following safety precautions before using SurfLink Programmer for the first time. Markings and Symbols The following markings and symbols are used in these safety precautions and/or on the device label. Within Europe, dispose of SurfLink Programmer according to local EU WEEE regulations. Regulatory and Service Information Classification • Classification to the Medical Device Directive: Class I. • Classification to EN 60950-1 Class II Continuous Operation.
IMPORTANT SAFETY AND USAGE INFORMATION Storage and Shipping Conditions: • Temperature: -20 to 70° C, -4 to 158° F • Humidity: 30 – 90% • No condensation Operating Conditions: • Temperature: 15 - 35° C, 59 - 95° F • Humidity: 30 – 90% • No condensation Avoid using SurfLink Programmer in areas subject to the following conditions: • Extreme heat or cold • Static electricity • Large amounts of dust • Rough handling Rough handling or dropping SurfLink Programmer can cause damage.
Regulatory Notices FCC ID: EOA-WP IC: 6903A-WP FCC Notice This device complies with part 15 of the FCC rules and with . RSS-210. Operation is subject to the following two conditions: . (1) This device may not cause harmful interference, and . (2) this device must accept any interference received, . including interference that may cause undesired operation . of the device. to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Waste from electronic equipment must be handled according to local regulations. 0673 © 2010 Paradigm, Inc. All Rights Reserved. BKLT0209-00-EE-XX Rev.
