User Manual

5
Angle cutting
Fig 2
Attention!
Always be sure that the tool is switched off and unplugged before adjusting the
machine, installing or removing accessories.
Raise the safety guard and loosen the allen screw on the shoe plate with the allen key. Pull
the shoe plate backward and set the desired angular adjustment according to the scale or
push the shoe plate forward for fixed Locks at 0°, 15°, 30° or 45°. Tighten the allen
screws again. Always replace the allen key in the allen key holder on the shoe plate
immediately after use.
Trimming edges
To trim edges or make dimensional adjustments, run the blade lightly along the cut edges.
Metal cutting
Always use a suitable coolant (cutting oil) when cutting metal. Failure to do so will cause
significant blade wear. The underside of the work-piece can be greased instead of using a
coolant.
 Use only special blades for metal.
Laser function
The laser function is to check the line and orientation. Press the laser function, make sure
it is in the ON position.
Adjust the machine accordingly and start your cutting operating.