User Manual

3
to perform adjustment.
Open the clamp levers. Take a sanding paper of the required grain size and place it on the
sanding pad. Make sure that the perforation in paper is aligned with the holes in
the pad. Then return the clamp lever to the original position to secure the paper. Repeat
the same process for the other end of the tool, maintaining the proper paper tension.
Switching ON/OFF
To switch on the machine press the ON/OFF switch (1). To switch off the machine,
release the ON/OFF switch (1).
Never use the machine for sanding magnesium work-pieces.
During the operation
Hold the machine firmly with two hands and put it on the surface to be processed only
when the motor attains full speed.
 don’t use the machine on the humid surface;
 during long work don’t allow overloading and overheating of the motor, make
work breaks;
 avoid mechanical damage of the machine;
 keep the machine away of intense heat sources and reactive materials, don’t allow
liquids and other matters come inside the machine;
 don’t not block ventilation slots in the housing;
 switch off the machine by the way of turning off the switch before disconnecting
the cable.
After work
 switch off the machine and disconnect the cable from the current source;
 clean the machine and accessories;
 keep the machine in conditions of temperature from +1°С to +35°С and humidity
not more than 80%.
Recommendations
Gently place the tool on the work-piece surface. Keep the sheet flush with the work-piece
at all times and move the tool back and forth.
Never run the tool without the abrasive paper. You may seriously damage the pad.
Never force the tool. Excessive pressure may decrease the sanding efficiency, damage the
abrasive paper and shorten tool life.