User Manual

5
Recommendations
Gently place the tool on the work-piece surface. Keep the belt flush with the work-piece at all
times and move the tool back and forth.
Never force the tool. The weight of the tool applies adequate pressure. Excessive pressure may
cause stalling, overheating of the motor, burning of the work-piece and possible kickback.
When the dust bag is about half full, remove the dust bag from the tool and pull the fastener out.
Empty the dust bag of its contents, tapping it lightly so as to remove particles adhering to the
insides which might hamper further collection.
Safety Instruction
Attention! Observe the safety rules when using the machine to avoid burning,
electrical shock or other injuring.
1. Make sure that the voltage of the power supply network as well as operation conditions
conforms to those described in this manual. Be especially prudent when working in the zone
of electric circuit wiring.
2. Keep your working place in order – the mess brings about injuring.
3. Don’t use the machine in places of increased humidity. Don’t work in raining conditions.
Keep the poisoning or pungent liquids and gases away of your working space.
4. Don’t touch grounded objects as water pipes, heaters etc. when working with the machine.
5. Don’t allow children and unauthorized person in your working zone.
6. Don’t overload the machine. It reduces the life of machine and can lead to injures as well.
7. Use the machine only for its intended purpose.
8. Don’t leave the machine working without care.
9. Choose the proper clothes. Hide long hairs under the cap. Use rubber gloves and protective
shoes when working outside.
10. Always use protective goggles while working. Use special protective mask if the dust is
generated abundantly.
11. Always carefully handle the electrical cable. Never carry the machine holding it for the cable.
Never pull out the cable from the power socket holding it. These actions may bring about the
electrical shock.
12. If the cable is damaged during work it is necessary to pull out the plug from power socket
not touching the cable. It is strictly prohibited to operate the machine with damaged
electrical cable.
13. Make sure that the machine is switched off when inserting the plug into power socket.
14. Be careful while working. Avoid working if you are tired.
15. Every time before switching on check all the working and protective parts. If any damaged
parts are discovered the repair works should be rendered in qualified service center.