User Manual

3
Operating instruction
Damage of the disc is possible even if the safety instructions are observed.
ALWAYS USE THE WHEEL GUARD even if you are going to use the
machine for the short period of time.
Before work
Check network voltage: it should conform to the data on the machine’s label.
Tool labeled with the 230 V, can be also connected to a power source with a
voltage of 220 volts.
Installation of the wheel guard
Always be sure that the tool is switched off and unplugged before attempting to
perform adjustment.
Install the wheel guard (1) in the position convenient for operating. Make sure that it
occupied the proper position and is not loose.
The wheel guard must be fitted on the tool so that the closed side of the guard always
points toward the operator.
Installation of the side handle
Attach the side handle firmly into the desired position. It can be installed in any of the
three locations on the machine’s housing.
Installing or removing the grinding disc
Attention! Always be sure that the tool is switched off and unplugged before
attempting to perform adjustment.
Use only the discs of well-known manufacturers before expire date that is
indicated on the package. Remember, that disc’s
properties are greatly influenced by the conditions
of storage.
Mount the wheel guard on the inner flange and put the
outer flange onto it.
To screw up the disc securely press the shaft lock to stop
the wheel and use wrench after that.
 IMPPORTANT: put the protruding part of the
outer flange close to disc if you mount sanding disc, put
the protruding part of the outer flange outside if you
mount cut-off disc.