Installation Guide

MAINTENANCE
16
9. After one self-cleaning program complete, then pull out the drain pipe of the water tank, drain the
cleaning solution down to the lower ice storage bin, also shake the unit slightly to drain out all of the water
completely. Then install back the drain pipe to the water tank slot tightly.
10. Repeat the step 8-9 again for 2 times.
11. Following the above program to clean the ice storage bin .
12. Then this special cleaning program nish, you can return to the regular ice making mode. And suggest
to discard the rst batch of ice cube.
CLEANING SUGGESTION
1) DAILY CLEANING
The ice shovel, door and the water dividing pipe should be cleaned by yourself per each day. At the end of
every day, rinse the ice shovel and wipe the both sides of the door with a clean cloth.
2) SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice-full detecting plate and the surface of the evaporator are to be
cleaned by yourself semi-monthly according to interior cleaning program.
3) SEMI-ANNUAL CLEANING
All the components & surfaces exposed to water or ice cubes, like ice storage bin, water tank, door,
evaporator, water pump, silicone tube, water dividing pipe, etc. should be cleaned by Using Nu-Calgon
Nickle Safe Ice-machine Cleaner per each 6 months. They should be cleaned by the serviceman according
to ice making assembly system cleaning program.
WIRING DIAGRAM