Installation Guide

MAINTENANCE

Periodic cleaning and proper maintenance will ensure efciency, top performance, hygienic, and long life.

The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if

you have pets, or the unit is used outdoors, or there are other special considerations.

NEVER keep anything in the ice storage bin that is not ice: Objects like wine and beer bottles are not only

unsanitary, but also it’s labels may slip off and obstruct the drain pipe.

EXTERIOR CLEANING

The door and cabinet may be cleaned with a mild detergent and warm water solution such as 28g of dish

washing liquid mixed with 7.5L of warm water. Do not use solvent-based or abrasive cleaners. Use a soft

sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting. The side steel

plate can discolor when exposed to chlorine gas and should be cleaned. Clean the steel plate with a mild

detergent and warm water solution and a damp cloth. Never use abrasive cleaning agents.

INTERIOR CLEANING

FOR ICE STORAGE BIN

The ice storage bin should be sanitized occasionally. Clean the bin before the ice maker is used for the rst

time and reused after stopping for an extended period of time. It is usually convenient to sanitize the bin

after the ice making system has been cleaned, and the storage bin is empty.

1. Disconnect power to the unit.

2. Open the door and with a clean cloth, wipe down the interior with a sanitizing solution made of 28g of

household bleach or chlorine and 7.5L of hot water (95 °F to 115 °F).

3. Rinse thoroughly with clear water. The waste water will be drained out through the drain pipe.

4. Reconnect power to the unit.

The ice scoop should be washed regularly. Wash it just like any other food container.

NEVER use solvent cleaning agents or abrasives on the interior. These cleaners may transmit a poor taste

to the ice cubes or damage the interior of the machine.

ICE MAKING PARTS CLEANING

During the using, periodically to clean these main system of your ice-maker. During the using,

periodically to clean these main system of your ice-maker.

1. Repeat above step to clean the water tank and other inner parts of the unit.

2. Especially, to the water dividing pipe on the evaporator, when the compressor and the water pump run

normally, but if there is no water owing out from the water dividing pipe or the water owing is very small,

please discharge this water dividing pipe to clean carefully. Clean each little holes on the water dividing

pipe displayed in the following illustration, make sure each hole is not clogged by something, then install

3. The length of cleaning period is related to your water

quality. And drain the water more frequently, the unit and its

water pump can work much longer.

4. When there are ice cubes on the surface of the evaporator,

but can’t fall off easily, do not use the mechanical substance

to remove it by force; Only press the “ON/FF” button for more

than 5 seconds, the unit will enter the ice melting process,

after some while, the big ice-cubes will fall down, then turn

off the unit and unplug the power cord to clean the surface of

the evaporator.

5. For the water tank and ice-full detecting plate