Replacement Part List

3
OPERATION
1. Connect hose assembly (as per Fig. 2).
2. Open both tank shut-off valve and hose shut-
off valve.
3. Open vent screw on ll cap.
4. This Gas Caddy operates in a gravity feed
mode, therefore Your gas caddy MUST BE
HIGHER than tank to be lled. Squeeze pump
handle repeatedly to start the ow of fuel. Hold
the pump handle to continue lling. Let go of
pump handle to stop ow of fuel.
5. Close vent screw and both shut-off valves.
6. Hang hose on hanger.
FILLING INSTRUCTIONS
1. Lay tank in horizontal position.
2. Ensure tank shut-off valve is closed. Remove ll cap.
3. Pump fuel. - DO NOT OVERFILL
4. Replace ll cap, ensure manual vent screw on cap is closed.
5. Containers should never be lled in or on the back of a pickup truck, marine craft, or any other
vehicle
6. Fill the container slowly to decrease the chance of static electricity buildup and to minimize spilling
or splattering.
7. NEVER smoke, use lighters, light matches, use cell phones or other electrical devices while lling.
LIFTING INSTRUCTIONS
1. IMPORTANT-TANK IS HEAVY, DO NOT attempt to lift alone.
2. Lay tank in horizontal position.
3. Use top pull handle and hand holds on base to lift. ONE PERSON AT EACH END.
LIFTING INSTRUCTIONS
1. Lay tank in horizontal position and close both shut-off valves.
2. Disconnect hose assembly and remove ll cap and Insert nozzle into ll neck.
3. Keep valve above nozzle. Open hose shut-off valve.
4. Squeeze pump handle repeatedly until hose is empty. Close hose shut-off valve.
5. Replace ll cap.
OF NOTE
PRODUCT MADE IN CHINA