Use and Care Manual

Additional Safety Rules for Demolition Hammer
1. Wear ear protectors.Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.Loss of control can cause personal injury.
3. Hold power tools by insulated gripping surfaces, when performing an operation where
thecutting tool may contact hidden wiring or its own cord.Cutting accessory contacting a "live"
wiremay make exposed metal parts of the power tool "live" and could give the operator an electric shock.
4. Wear a
dust mask. Do not inhale the harmful dusts generated in drilling or chiseling operation. The
dust can endanger the health of yourself and bystanders.
5. Be sure the bit is secured in place before operation.
6. Under normal operation, the machine is designed to produce vibration, the screws and bolts
can come loose, causing a breakdown and accidents. Check tightness of them carefully before
running.
7. In cold weather or a l
ong time tool not be used, please keep the tool running without load a
few minutes to warm up the grease inside, otherwise hammering function is difficult to get.
8. Be sure you stand stably and no one is below when you using tool is in high location.
9. Hold the tool firmly
with two hands.
10. Don't touch any moving parts.
11. Don't leave the tool running itself, operate tool only when hand-held.
12. Don't point the tool to anybody for the bit could fly out in case.
13. Don't touch the BIT OR PARTS CLOSE TO THE BIT immediately after operation, they may
extremely hot and could burn your skin.
14. Any damage and abnormal happen, please stop to use immediately and disconnect it,
ask authorized serve center to check and repair.
15. Parts replace: Only original Stark's parts can be used to replace by authorized service center.
16. Right use accessories and parts: Don't use other parts and accessories which not
mentioned in the manual otherwise may cause injuries!
17. Special attention to voltage: Before connect the power tool, please make sure the rated
voltage on the tool can match the power supply, otherwise the power tool may be damaged and
cause injuries.
18. Don't wipe plastic part with solvent: Solvent such as gasoline,thinner, alcohol etc.these kind
of chemical material, are not allowed to use, water or soap are recommended!
19. In case of damages the replacement of the plug or the supply cord shall always be carried out
by themanufacturer of the tool or his service organization
20. If the replacement of the supply cord is necessary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
Residual risks
Even when the power tool is used as prescribed it is not possible to eliminate all residual risk
factors. The following hazards may arise in connection with the power tool’s construction and
design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Damages to health resulting from vibration emission if the power tool is being used over longer
period of time or not adequately managed and properly maintained.
5