Manualshelf

Replacement Part List

ManualsBrandsStark ManualsGas Leaf Blowers7 HP 150 MPH RATO 209 cc 1200 CFM Walk-Behind Gas Powered Lawn Sweeper Leaf Blower
10111213141516171819
SAFETY WARNINGS
Set the throttle control lever to the SLOW position to reduce stress on the engine when work is not being performed.
Lowering the engine speed will help extend the life of the engine, as well as conserve fuel and reduce noise level.
IDLE SPEED
To stop the engine in an emergency, simply turn the engine switch to the OFF position. Under normal conditions,
use the following procedure:
1. Move the throttle lever to the SLOW position.
2. Let the engine idle for one or two minutes.
3. Turn the engine switch to the OFF position.
4. Turn the fuel valve lever to the OFF position.
STOP ENGINE
Sudden stopping at a high speed under a heavy load is ot recommended. Engine damage may result.
Do not move the choke control to CLOSE to stop the engine. Backre or engine damage may occur.
ADJUSTING THE AIR FLOW DIRECTION
• The air ow direction can be adjusted between 27 degrees upward to 27 degrees
downward, total 7 positions.
• Direction adjustment is achieved by using the ow angle adjustment control lever to
move the air ow louver.
Move the lever upward to direct airow downward or move the lever downward to
direct airow upward. Angle change between each position is 9 degrees.
Before attaching/storage the attachment, move the ON/OFF Engine Switch to
OFF position.
The front discharge chute is used to redirect the air ow to the front of the blower. Attach it when needed.
ATTACH THE FRONT DISCHARGE CHUTE
1. Loosen the knob located on top of the discharge chute.
2. Orient the attachment so the “THIS SIDE UP DURING USE”
is up.
3. Slide the attachment over the discharge chute. The slot on the
top of the attachment will mate with the bolt of the attachment
knob.
4. Hand-tighten the attachment knob to secure the attachment.
When not in use, the front discharge chute can be stored under
the frame at the rear of the blower. Take follow steps to secure the
attachment for storage.
1. Orient the attachment so the “THIS SIDE UP FOR STORAGE” is
up. Insert the attachment with this direction under the frame of unit. It
will be supported by a bracket under the frame.
2. Secure the attachment by rotating it so the pin on the frame will
insert into the slot on the attachment.
STORAGE OF THE FRONT DISCHARGE CHUTE
12