Replacement Part List

6
2-4．Stop engine without fail before replenishing fuel tank.
Never replenish gasoline while the engine is
running or remains hot otherwise spilled or
evaporated fuel is liable to catch fire from engine
sparks or muffler heat．
Wipe off spilled fuel,if any，before starting engine．
Be careful not to Spill fuel．
2-5．Keep jnflammables away from the vicinity of
the exhaust port．
Be careful with gasoline match,straw and other
inflammables,since the exhaust port is subjected
to a high temperature．
3．Starting
Gasoline Engine
3-1．Turn the STOP SWITCH clock-wise to the position
"I"(ON)． Fig-3
3-2．Open the fuel cock． Fig-4
3-3．Set the speed control lever 1/3 to 1/2 of the way
towards the high speed position． Fig-5
3-4．Close the choke lever．
If the engine is warm or the ambient temperature
is high，open the choke lever half-way．or keep it
fully open．
If the engine is cold or the ambient temperature is low,
close the choke lever fully． Fig-6
3-5．Pull the starter handle slowly until
resistance is felt．This is the
"compression"point．Return the handle
to its original position and pull
swiftly．
Do not pull out the rope alI the way．
After starting the engine，allow the
starter handle to return to its original
position while still holding the handle．
Diesel Engine
3-6．Tum the throttle lever to START position(open by
about 30 degrees) Fig-5-D
3-7．Operate Starter
In case of recoil starter．
By pulling the starter knob slowly,you will reach
such point where resistance become
strong(compression point)．by pulling it further,
you will Find a point where resistance is reduced．
Return the knob but slowly return it original
Fig-7-D