Replacement Part List

11
SPECIFICATIONS
BEARINGS
The following bearings ate sealed：
Centrifugal clutch-grease lubricated
Vibrator-oil bath lubricated
FINISH
The machine is finished in gold equipment enamel, the handle in black baked enamel. Exposed metal surfaces are zinc
electroplated for corrosion protection.
TROUBLESHOOTING
SYMPTOM POSSIBLE CAUSES AND CORRECTION
Motor will not start.
-Check the ON/OFF switch to ensure that it is switched ‘ON’.
-Check the fuel supply.
-If a Honda or Kama motor is fitted check the crankcase oil level as an oil
sensor device is fitted to these motors which prevents starting and stops
the motor when the oil level is low.
-Ensure the spark plug ignition lead is connected
-Chock the carburettor let and bowl to ensure they are clean.
Motor stops.
-Check:the fuel supply.
-Check that the fuel cock is turned on.
-Check the condition of the air filter.
Petrol Motor lacks power.
-Check the condition of the air filter．
-Check the condition of the spark plug.
Insufficient vibration
-Check for a slipping or a missing v belt.
-Check that the motor governed speed is 3,500r/min.
Machine is not moving freely
-Check the under side of the plate for a build up of material
Model
61012
Engine
Air-cooled, 4-cycle, single cylinder
Engine type
Petrol, Loncin 200F
Power kw(hp)
4.7(6.5)
Weight kg(lbs)
180(287)
Frequency vpm
4600
Centrifugal Force kn
22
Compaction Depth cm(in)
50(19)
Travel Speed cm/s(in/s)
20(8)
Efficiency m2/hr (ft2/hr)
450(4844)
Plate Size cm(in)
66X38(26x15)
Dimension cm(in)
82X44.5X100(32X17.5X40)