Use and Care Manual

Graphic 5
6.2.5 Cleaning：
6.2.5.1. Clean the air filter elements if they are to be reused.
Paper air filter element：Tap the filter element several times on a hard surface to remove dirt，
or blow compressed air[not exceeding 207 kPa(2.1 kgf/cm
2
，30 psi)] through the filter element
from the inside．Never try to brush off dirt；brushing will force dirt into the fibers．
Foam air filter element：Clean in warm soapy water，rinse，and allow to dry thoroughly. Or
clean in non-flammable solvent and allow to dry．Dip the filter element in clean engine oil， then
squeeze out all excess oil．The engine will smoke when started if too much oil is left in the foam．
6.2.5.2. Wipe dirt from the inside of the air cleaner case and cover，using a moist rag. Be
careful to prevent dirt from entering the air duct that leads to the carburetor．
6.3 Engine Oil
See Graphic 6
6.3.1 Drain oil while engine is still warm．
Note：In the interests of environmental protection，place a plastic sheet and a container
under the machine to collect any liquid which drains off．Dispose of this liquid in
accordance with environmental protection legislation．
6.3.2 Place the rammer so it is resting on its shoe on a level surface．