PRO SERIES AUTO FEED MIG 130 WELDING WELDER 110/220V ITEM: 55019 OWNER’S MANUAL AND SAFETY INSTRUCTIONS SAVE THIS MANUAL: KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY, OPERATING, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES. WRITE THE PRODUCT’S SERIAL NUMBER ON THE BACK OF THE MANUAL NEAR THE ASSEMBLY DIAGRAM (OR MONTH AND YEAR OF PURCHASE IF PRODUCT HAS NO NUMBER).
IMPORTANT SAFETY INFORMATION GENERAL SAFETY WARNINGS Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. SAFETY The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur.
IMPORTANT SAFETY INFORMATION Keep head out of fumes. DO NOT breathe exhaust fumes Use enough ventilation, exhaust at arc, or both, to keep fumes and gases from breathing zone and general area. If engineering controls are not feasible, use an approved respirator.
IMPORTANT SAFETY INFORMATION DO NOT weld or cut on materials having a combustible coating or combustible internal structure, as in walls or ceilings, without an approved method for eliminating the hazard. DO NOT dispose of hot slag in containers holding combustible materials. After welding, make a thorough examination for evidence of fire. Be aware that easily visible smoke or flame may not be present for some time after the fire has started.
DIAGRAMS AND SPECIFICATIONS MIG TORCH SELECTOR VOLTAGE KNOB WIRE BRUSH GROUND CABLE & CLAMP CHIPPING HAMMER SPOT TIMER TENSION WIRE POWER SWITCH WORK INDICATOR POSITIVE TERMINAL WELDING MASK NEGATIVE TERMINAL SPECIFICATIONS FEATURES Variable Feed Speed Control 1X welder machine Torch With Full On / Off Safety Control 1X welding gun Automatic Thermal Safety Protection 1X Welding Wire Adjustable 4-setting heating 1X welding mask Gas Less Welder 1X brush Torch With Full On / Off Safety Cont
PARTS AND ACCESSORIES 4
PARTS AND ACCESSORIES WARNING! TO PREVENT DEATH FROM APHYXIATION DO NOT open gas without proper ventilation. Fix gas leaks immediately. Shielding gas can displace air and cause rapid loss of consciousness and death. Shielding gas without carbon dioxide can be even more hazardous because asphyxiation can start without feeling shortness of breath.
OPERATION The Mig100 130 welder requires a dedicated 120 AC , 60 Hz power input. Please check carefully the welder you have in hand is 120V before using. If using an extension cord, use a minimum 12 AWG cord for up to 25 feet. CHANGING THE DRIVE ROLLER The MIG100/130 comes set up and ready to use 0.035″ (0.9mm) Flux-Core Wire. If 0.03″ (0.8mm) wire is to be used, the drive roller needs to be adjusted. Adjust the drive roller according to the following procedure: 1. Open the top door of the welder. 2.
OPERATION 9. Turn on the machine and set the wire speed. 10. With the gun pointed away from you and others, depress the trigger to begin feeding wire. NOTE: Watch the drive roller to see if any slipping is occurring between the roller and wire, if so, turn the machine off and tighten the Pressure Adjuster turn and test again. 11. Once the wire exits the end of the torch, install the contact tip and nozzle. Cut the wire about 1/4″ from the end of the contact tip.
OPERATION TYPES OF WELD JOINTS 8
PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.
