Installation Guide
Stay alert, watch what you are doing and use common sense when operating this tool. DO NOT use
a power tool while you are tired or under the inuence of drugs, alcohol or medication. A moment of
inattention while operating power tools may result in serious personal injury.
Prevent unintentional starting. Ensure the Switch is in the off-position before connecting to power source,
picking up or carrying the tool. Carrying power tools with your nger on the Switch or energizing power
tools that have the Switch on invites accidents.
Use personal protective equipment. Always wear eye protection. Safety equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal
injuries.
DO NOT overreach. Keep proper footing and balance at all times. This enables better control of the
power tool in unexpected situations.
Remove any adjusting key or wrench before turning the tool on. A wrench or a key left attached may
result in personal injury.
Only use safety equipment that has been approved by an appropriate standards agency.
Unapproved safety equipment may not provide adequate protection. Eye protection must be ANSI-
approved and breathing protection must be NIOSH-approved for the specic hazards in the work area.
DO NOT use the power tool if the Switch does not turn it on and off. Any power tool that cannot be
controlled with the Switch is dangerous and must be repaired.
Disconnect the plug from the power source before making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
2
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool
or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained user.
Maintain power tools. check for misalignment or binding of moving parts, breakage of parts and any other
condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account
the working conditions and the work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
DO NOT allow the cutter to stop turning while the machine is runnng. This provides better control of the
cable and helps to prevent twisting.
Keep a gloved hand on the cable whenever the machine is running.
Install this product on a solid, at surface that is capable to support the weight of the Drain cleaner.
DO NOT put too much stress on the cable. In the course of drain cleaning, if the cable encounters an
obstruction, it may stress the cable and cause the cable to twist and kink or break. This may result in
personal injury or damaged equipment or pipes.
Position the drain cleaner within two feet of the drain opening.
One person must control both the cable and the foot switch.
Reverse motor direction only whne pulling the cable out of the pipe or obstruction. Make sure the drum has
stopped turning before changing the power switch.
Keep hands away from rotating drum and distributor tube. Do not reach into the drum if the power is on.
Avoid electric shock. DO NOT operate this tool if the operator or machine is standing in water.
WARNING: People with pace makers should consult their physician before using the product.
IMPORTANT SAFETY INFORMATION