User Manual

4
After work
 switch off the machine and disconnect the cable from the current source;
 clean the machine and accessories;
 keep the machine in conditions of temperature from +1°С to +35°С and humidity
not more than 80%;
 when long operation breaks occur put the technical oil onto the spindle and chuck.
Recommendations
 Drilling of wood
The best result when drilling of wood is achieved by applying the special drilling bits for
wood.
 Drilling of metal
To avoid the sliding of the drilling bit off the desired point mark the dot with a center
puncher.
ATTENTION:
 Don’t press on the drill excessively. It will not accelerate the process of drilling.
 While drilling hold the machine firmly and press carefully.
 Stuck in the material drilling bit is easily freed by the way of applying the reverse
rotation.
 For the drilling of the small size objects use vice and clamps.
Maintenance
For safe and reliable operation please remember that repairing, maintenance and
adjustment of the machine of Stark brand is to be made in the special service centers of
Stark company with applying only original spare parts.
Safety Instruction
Attention! Observe the safety rules when using the machine to avoid
burning, electrical shock or other injuring.
1. Make sure that the voltage of the power supply network as well as operation
conditions conforms to those described in this manual. Be especially prudent when
working in the zone of electric circuit wiring.
2. Keep your working place in order – the mess brings about injuring.
3. Don’t use the machine in places of increased humidity. Don’t work in raining
conditions. Keep the poisoning or pungent liquids and gases away of your working
space.
4. Don’t touch grounded objects as water pipes, heaters etc. when working with the
machine.