User's Manual

7. Product parameters
7.1 PU Receiver
a. Receiver Frequency: 2.4G
b. Frequency: 12 channels (CH1:2413MH, CH2:2418MHZ, CH3:2423MHZ, CH4:2428MHZ, CH5:2433MHZ,
CH6:2438MHZ, CH7:2443MHZ, CH8:2448MHZ, CH9:2453MHZ, CH10:2458MHZ, CH11:2463MHZ,
CH12:2468MHZ)
c. Power supply: AC110~240V, DC IN: 5V 2W, Current consumption: 400mA
d. Operating Temperature: 0°C~40°C/ 32°F~104°F
e. Battery life: 12 hours
PU Receiver complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Additional information on Specific Absorption Rates (SAR) can be found on the FCC website at
(http://www.fcc.gov/encyclopedia/radio-frequency-safety)
PU Receiver
is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
The guidelines are based on standards that were developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all
persons, regardless of age and health.
The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg.
The SAR for this device is compliant with these SAR exposure requirements.
The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and
should be avoided.
For body-worn operation, this device has been tested and meets the FCC RF exposure guidelines when used with an
accessory that contains no metal and that positions the handset touching the user’s body.
The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance
with the FCC RF emission guidelines.
SAR information on this device is on file with the FCC and can be found under the Display Grant section of
(http://transition.fcc.gov/oet/ea/fccid/) after searching on FCC ID 2AA9G-1150P.